#Igor pro 7 peaks driver#

Also, the ability of the DAC output buffer to driver voltages close to the power rails, decreases with increasing output current, but in most applications the output is not sinking/source much current as the output voltage approaches GND. The specifications assume Vs is 5.0 volts. (11) Maximum and minimum analog output voltage is limited by the supply voltages (Vs and GND). An adjacent AIN pin refers to multiplexer channel

(10) Typical crosstalk on a grounded AIN pin, with 20Vpp sine wave onДЄdjacent AIN pin. Required settling time to meet specifications can depend on the source impedance of the signal, channel order, resolution index, and gain/range. Second, if sampling more than 1 channel, there can be a more complex settling error if the analog input system needs to quickly swing from one voltage to another. First, there is a simple offset error due to the input bias current flowing through the source impedance. For source impedance greater than this value, there are two error sources that need to be considered. As long as the source impedance is not over this value, there will be no substantial errors due to impedance problems. (9) The key specification here is the maximum source impedance. The device can handle brief transients with much higher voltages (e.g. Protection level is the same whether the device is powered or not. (8) Maximum voltage, compared to ground, to avoid damage to the device. (5) This is compared to the value stored during factory calibrationДЎ3V) on a single channel will generally affect only even or only odd channels. The current rating is the maximum current that should be sourced through the U6 and out of the Vs terminals And example of bus powered would be a hub with no power supply, or many PDA ports. Self-powered would apply to USB hubs with a power supply, all known desktop computer USB hosts, and some notebook computer USB hosts. Self- and bus-powered describes the host/hub. (4) These specifications are related to the power provided by the host/hub. See Section 3.1 for more timing information

#Igor pro 7 peaks windows#

Measured by timing a Windows application that performs 1000 calls to the Feedback function. (3) Total typical time to execute a single Feedback function with no analog inputs. (2) Typical current drawn by the U6 itself, not including any user connections The input range of the analog inputs will be reduced approximately 3 volts for each 1 volt that VS is below 4.5 volts. The maximum output of the DACs will be limited by VS. The voltage drive capability of the current sources will be reduced. The hi-res converter on the U6-Pro is not specified for operation below 4.75 volts. (1) Device should operate down to about 3.5 volts, with the following considerations. Specifications at 25 degrees C and Vusb/Vext = 5.0V, except where noted.